Trojan Boat Forum

If there is enough of you guys that have manuals that you want to share. I can build a site and maintain it as you guys send me the manuals. And proved them so everyone can view and down load them for there personal use. Rodman That would be great. Send me your e-mail address and I'll send you the ...

The F-36 has an exhaust fan in the head. I'm looking for the fiberglass cover that hides the outlet hole on the port side of the hull. It is a fiberglass shell that bolts or screws on the hull to covers the hole where the exhaust fan exits the boat. There is a similar cover on the starboard side tha...

The vanes on the impeller will break off over time and will need to be replaced. The impeller may have been replaced, but the pieces will end up in the trans oil cooler and can restrict the flow of water. You should check your cooler to see if it is being blocked. You can use a wet/dry vacuum to suc...

Ok guys....I winterized my F32 for the 1st time today...I removed the thermo stats them disconnected the raw water cooling lines one at a time. I then pumped 5 gallons of the pink RV minus 50 f anti freeze thru each block until I saw pink fluid from the exhaust ports......Did I do it alright ? Im f...

I've got the Chrysler 440's in my boat. If your going with gas engines the F 36 needs big block engines to run the boat the way the designers intended.

I have tried to send the service manuals that I have to a few people that requested them and they were returned as undeliverable. If you requested a set of manuals, but did not receive them, try requesting them again. Send your request to: gjrylands@att.net In the subject space put: Onan Manuals Sen...

The push button switch you should be using is the extra heavy duty switch that is rated at 35 amps @ 12 volts. West Marine sells the switch, model # 270876 which comes with a black water-repelent cover. Cole # M-626.

I have a shut off valve right at the inlet for my dock side water inlet that I shut off when I leave the boat for any length of time. I could and probable should shut off the water at the pedistal, but I don't. The inlet is on my back deck so if there were any failure to the hose, water would run on...

I've been away from the forum for some time. If you have requested a copy of the manuals and didn't receive it I'm sorry that I missed your request. Send me your e-mail address again and I'll try to get it to you. I will be sending the manual as an attachment so I need to send it directly to you and...

Most oil pressure sending units have a 1/8 inch pipe thread.

I've been off line for a while. I was living on my boat and had internet service at the harbor. Once I pulled the boat, I lost the service. Well, I'm back on line. If anyone else wants a copy of the manual send me your email address in a PM or email me. gjrylands@att.net The manuals I have are from ...

Welcome! Very nice looking boat.

Send me your email address in a PM and I'll send you the pdf file.

Today I moved my boat to the boatyard. It will be pulled in the next day or two. I picked the right day to make the move. The lake was flat and the temperture was 70 degres. The boat ran great and it would have been perfect if it wasn't for the barge in the lock. Had to wait about an hour and a half...

My F36 has 20x21 props with 1 3/8 shafts. Chrysler 440 engines with 1.91:1 Velvet drive trans & reduction gear. This was the stock setup in '79