Trojan Boat Forum

Did you remove the studs that the risers bolt up to? and if so do they thread standard clockwise for tightening

My port Chrysler 360 engine had the piston hitting the spark plugs. It actually broke the center ceramic part of the plugs (5) plugs were smashed. I compression tested the motor and it was deemed the motor needs to be replaced. Has anyone replaced a engine and does the salon glass need to be removed...

Thanks but the Transmission has been removed already, I can probably look at someone else boat and see what direction theirs turns. Did you know anything about the drive shaft ?

Thanks for your help and you all continue to be very helpful, I am now in the process of getting a remanufactured transmission for the starboard engine. My transmission got stuck in forward gear and could not be serviced by the local transmission shop because they could not get the case open. I coul...

Thank you all very much for taking your time to help me with my boat. I ordered a copy of Nigel Calder's Boatowner's Mechanical and Electrical Manual, and I am removing the impellers. Hopefully they are intact and I will not have to back flush the system or I will need some more help. Thanks again, ...

Thank you very much I just put a new belts on those units. Do you know of a site where I can order them on line? Are they called raw water pump impellers?

Thank you both for your response. Big D, I did not hear the pump for the sink running when I turned on the breaker for the water pump. Is the pump automatic when you turn on the faucet?

I have twin 360 Chrysler engines, my starboard engine start switch will not shut the engine off. Does anyone know where to get this switch? I have a cruisair a/c system which I am told there is a water valve which needs to be open to operate, can you tell me where the valve is? Are there water valve...

I am the new owner of a 1983 Trojan F32 with twin Chrysler 360 engines, The boat has sat for approximately four years. I have the boat running, but I was told there are two rubber impellers that should be changed about every two years to keep my boat from overheating. Is anyone familiar with these i...