Trojan Boat Forum

I have one side of our F32 stair hardware missing. Have looked all over at marinas and this web site . Anybody have an idea who might have a set of these chrome brackets? Call Bob what you see in the online store is just a small fraction of what Beacon has. Beacon Marine Supply © 2023 Forks Townshi...

Tgornik wrote: ↑Mon May 01, 2023 12:10 pm

Thought of this but would still have to mess with the diameter of the hole so just decided to plug and start over..

Thanks again.
Tg

If going to a transducer that is larger thread and nut I plug the hole by epoxy in a piece of wood so center the hole saws bit. Makes it easier

Hampton Va Salt ponds area

Engines look great

Very nice, moving along. You're just up the bay from me.

The 12 to 1, I believe refers to the hole Diameter. I also believe 12 to 1 is way overkill for a small hole like this. I would taper the hull a bit and grind some around the edges ( not as deep as your drawings ) fill and glass over. I have done this more than once without issues. Another easier but...

I like it.

You may want to to contact Beacon marine. They should have the shipping height.

Give Robert Cushman a call at Beacon marine..

Bob Cushman, Owner
Beacon Marine Supply
Bob@BeaconMarineSupply.com
(609)713-4602

http://www.trojanboats.net/wforum/viewt ... c6f8cb17bf

Beacon marine sells pre cut packing.

Give Bob a call.

Beacon Marine Supply © 2023
Forks Township, PA and Columbia, PA
bob at beaconmarinesupply dot com
609-713-4602

hope it's ok to piggyback on this thread we are in marina del rey southern california we have owned the boat for 3 years now we have not painted the bottom and it is likely that the previous owner did not either (maybe 5 years) the service that cleans the bottom is not complaining and says there ar...

Moderator wrote: ↑Mon Mar 27, 2023 11:17 pm You could make bushing or spacer. Or just don't overtighten

Make a spacer, should be easy and no worries.

I don't know of any Trojans with them. However I have a friend with them on a 42 ocean. He likes them over regular trim tabs. Not sure if its auto system. With that said it would be much cheaper to increase your tab size.

The model # is part of the hull ID# You most likely have a model 440

The Aft wall was plywood and made to be removable. You do have the aft engine correct? Later models had the engines under the salon floor. Aft decks were known to leak many owners fiber glass the aft decks to fix the leaks many are rotted. Do you have the model number? Its located on plate on or by ...