This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.
Note: Negative or inflammatory postings will not be tolerated.
Took over a project (25') and need to know how to plumb this engine for raw water cooling. It has a single pocket pump and an automotive pump also. The manifolds look to have been fed in the top front and also the bottom rear side, based on the fittings. I can't figure how to plumb it back up again. Is there anyone that would know, or is there a diagram that I can get for this application. Thanks