Trojan Boat Forum

behind the toilet I find wires for the shower drain pump and switch
and wires going to the vacuflush level lights
but nothing for the vacuflush pressure switch
any other thoughts?

thanks for that I remodeled the head so it is a bit awkward but easy for me to access that area I have seen the wires for the shower drain switch but not the vacuflush I will check again the radar arch was a project but not too difficult the side panels were not easy to remove because of all the cau...

Posssibly an odd request vacuflush system I am trying to trace the path of the hot wire that goes to the vacuum pump switch at the vacuum tank I am looking for an easier place to tap into it I can see that it goes from the switch and disappears into a hole right by the forward shower drain almost ce...

thanks guys
serial number is 76868
I bought a DB Electric from Amazon
Looks like it will work, I'll Let you know if it doesn't.
As for the belt, that crusader number gives me a spec of 49 1/8" which is too long.
I will use the old belt as a guide.

rr

replacing starboard alternator
it is a one wire
does anyone have a part number?
I found mando 39200
prestolite 39064
Motorola MR

also current belt size is 47 5/8" which seems a bit long

thx

rr

can't say if it was burned up
I did not see all the parts when it was broken down
the parts I did see suffered from major corrosion

I am now thinking both engine problems at the same time was just a wierd coincidence

still trying to figure out what happened I just replaced the port starter motor the old one was in such bad shape it was not rebuildable does anyone know if it is possible that a short in the starter motor could drain the battery so much that the alternator could not keep up? that would explain why ...

got the starboard filter off today no debris in the bowl the problem is only with the port tank excessive amount of debris is it possible the float on the sending unit was made of cork and has disintegrated? the debris looks like ground up cork the filter is mounted high I am planning on installing ...

never mind the boat
what kind of car is that with the bubble top?

I took the port fuel filter off today It was really nasty I will compare it with the starboard side in the next day or two How often should they be changed? engine hours or calendar? Also I was planing on installing the anti-syphon valve after the filter The filter is close to the fuel outlet and al...

That's my understanding as well
But something is not right
Both batteries were being drained
I think the dc/dc charger is the culprit
But why both batteries?

thank you
I will check it out

rr

I just installed a 100ah lithium battery to run my 1000 watt inverter I installed a Victron 30amp dc/dc non isolated charger to charge the lithium battery The dc/dc charger is powered by my starboard agm start battery On a 3 hour trip (around 3000rpm) with a fully charged lithium battery no issues. ...

fyi With a little modification my plan worked I installed a line voltage relay (normally open) I powered it with the same a/c in of the inverter One leg of the charger is interrupted by the relay When connected to shore power or generator the relay closes and the charger is energized When there is n...

my port engine was starved for fuel I had to open up the fuel crossover to keep it running floscans showed little fuel from port while the starboard made up the difference I have had problems in the past that were caused by a clogged anti syphon valve I am currently running without an anti syphon va...