11 meter dinette

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
kcgarza
Registered user
Posts: 4
Joined: Tue Feb 14, 2017 2:34 pm

11 meter dinette

Post by kcgarza »

Help!! We have a new to us 1985 11 Meter dinette. I think we have the original table but we can’t figure out how it goes into a bed. Also should there be extra filler cushions or just the back dinette cushions? Any tips or tricks to make it more comfortable for some over night guests?
User avatar
prowlersfish
2024 Gold Support
2024 Gold Support
Posts: 12645
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: 11 meter dinette

Post by prowlersfish »

You should be ble to fold or remove the leg and lift the table off the wall mounts. It then fits between the seats, there should be a lip for it to sit on. The seat backs are the cushons.
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
kallen
Sporadic User
Posts: 120
Joined: Wed Jun 04, 2008 8:48 pm
Location: Ivy lee, ontario,canada

Re: 11 meter dinette

Post by kallen »

On my 81 F-32 the dinette table had to be lowered (leg collapsed) to remove it from the bracket. Not up.
User avatar
captainmaniac
2024 Gold Support
2024 Gold Support
Posts: 1917
Joined: Sat Apr 30, 2005 10:26 pm
Location: Burlington, Ontario

Re: 11 meter dinette

Post by captainmaniac »

kallen wrote: Tue Aug 03, 2021 8:49 am On my 81 F-32 the dinette table had to be lowered (leg collapsed) to remove it from the bracket. Not up.
I had posted this a few years back but the picture appears to be gone from the original post... Don't know if it is the same on the Internationals, but for the F32 the 'hinge' where the table meets the wall works like this... To unfasten the table: fold the leg, lower the outside edge of the table until top of hinge / bracket clears, then lift the back edge up and out. To put it back, just reverse: with outside edge of table low, place bracket at back edge into the trough, raise outside edge of table to lock it in the bracket, then put leg back in place.

Dinette Table Latching
Dinette Table Latching
Dinette Table Latching v2.jpg (31.92 KiB) Viewed 3166 times
Post Reply