Sherwood E35 pump question

AndyF32 · Post by **AndyF32** » Mon Dec 03, 2012 10:31 pm

Is 1/16 to 3/32 of radial movement on a sherwood E35 pump reason for a full rebuild kit? Both pumps have about the same amount of play and the bearings seem to spin fine.

Thanks in advance for the help.

[/img]

prowlersfish · Post by **prowlersfish** » Mon Dec 03, 2012 10:43 pm

If the bearing sounds ok ,not a dry sound or rumble then you should be ok a this pump uses a single ball bearing . the shaft goes in to the rear cover/bushing that stabilizes the shaft . If your not sure the bearing is only about $20 , so it not a big deal .

AndyF32 · Post by **AndyF32** » Tue Dec 04, 2012 8:21 pm

Thanks for the reply. I will install new impellers in the spring and look at them again in a couple of years.