modified dinette table and one tiny project
Posted: Fri Oct 25, 2013 7:41 pm
Hi all.....
I had mentioned that I was close to finishing my dinette table. Pretty much done save the drawer faces and pulls (waiting for the pulls) but its close enough to complete to give you an idea of what I was looking for - more drawer space.
Also, a quick job of redoing the stock cupboard latches to give them a bit of a more modern look.
If anyone wants to do this, (dinette) the total cost was approx. $300, the bulk of the cost being the teak veneer and the printer drawer slides. My intention is to likely follow the same pattern for the galley counter this winter unless I go with a corian countertop - still haven't made up my mind.
Anyways, photo's attached
I had mentioned that I was close to finishing my dinette table. Pretty much done save the drawer faces and pulls (waiting for the pulls) but its close enough to complete to give you an idea of what I was looking for - more drawer space.
Also, a quick job of redoing the stock cupboard latches to give them a bit of a more modern look.
If anyone wants to do this, (dinette) the total cost was approx. $300, the bulk of the cost being the teak veneer and the printer drawer slides. My intention is to likely follow the same pattern for the galley counter this winter unless I go with a corian countertop - still haven't made up my mind.
Anyways, photo's attached
- Started with four hand cut drawers 2x 8.5" x 12" and 2 12"x12" drawers
- IMG_0116.jpg (94.6 KiB) Viewed 3287 times
- after stripping the old surface, added a teak veneer and a decorative inlay
- IMG_0119.jpg (95.21 KiB) Viewed 3287 times
- added mounting surfaces and installed pencil slides in this bottom view
- IMG_0126.jpg (118.56 KiB) Viewed 3287 times
with envy