DC system failure of F32
Posted: Sat Jul 04, 2015 3:27 pm
I have an F32 and when my air conditioner stopped blowing cold air, we determine one of the connections in the switch was bad. So, before disconnecting and replacing, I turned off the AC electrical system from shorepower and turned the battery switches to off (both of them). I then fixed the air conditioner switch and turned the battery switches back on and then the shorepower. I did not note that the CO detector, which normally resets with the battery switches, did not do so (just remembered it later.) Then yesterday when I tried to turn on my ventilation blowers, nothing happened. All interior DC lights did not work, the nav lights would not turn on, the head will not flush and the bilge pumps won't run.
Any ideas what I should check? I reviewed all the fuses on the right side of the panel. One was bad and I replaced it but nothing happened. The others will be checked once I get my meter's battery replaced so I can check all of them. I don't know if there is a main "RESET" switch ... I am not knowledgeable at all about electricity but my boat manual did say the bilges should be working even if we turn off the battery switches so I'm afraid it is something different.
Your input is greatly appreciated.
Any ideas what I should check? I reviewed all the fuses on the right side of the panel. One was bad and I replaced it but nothing happened. The others will be checked once I get my meter's battery replaced so I can check all of them. I don't know if there is a main "RESET" switch ... I am not knowledgeable at all about electricity but my boat manual did say the bilges should be working even if we turn off the battery switches so I'm afraid it is something different.
Your input is greatly appreciated.