Size

larglo · Post by **larglo** » Tue Nov 10, 2009 11:44 am

Hi all,

I am wanting to replace the oil pressure sending unit in my F25- HT. The sending unit is in a difficult location to remove, so haven't done that yet.

I would like to order the water sender and the oil press sender, but I am not sure what size the oil sending unit is. I can see that the stem with the threads is about half the size of the water temp stem, which 1/2".

All West Marine have on line is the 1/8" - 80psi & 1/8"-100psi. Does anyone out there know what size I should order? Perhaps some of you with a F26 would know.

Thanks for any help.

Larry

g36 · Post by **g36** » Tue Nov 10, 2009 12:10 pm

call beacon marine the website sponser see if they can help

chauzer · Post by **chauzer** » Tue Nov 10, 2009 2:08 pm

you might have to reduce it down.

gjrylands · Post by **gjrylands** » Fri Nov 13, 2009 5:17 pm

Most oil pressure sending units have a 1/8 inch pipe thread.