Water ingress - Salon F-32

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
User avatar
bjanakos
Moderate User
Posts: 498
Joined: Mon Sep 29, 2014 1:00 pm
Location: Richmond, TX.
Contact:

Water ingress - Salon F-32

Post by bjanakos »

I tore up the old (and what I believe to be original carpeting) in the salon yesterday and notices some water damage on the floor in the aft solon corners. I will have to do a cut and replace, but I am curious to know if there is a typical area this comes from?

I would get some water ingress on my Slickcraft through the sliding windows during heavy rain or sea spray... Not much I could have done about that except seal the windows shut.
User avatar
Stripermann2
Ultimate User
Posts: 3027
Joined: Fri Jan 19, 2007 9:11 am
Location: Solomon's Island, MD

Re: Water ingress - Salon F-32

Post by Stripermann2 »

Any hardware on the bridge, railing screws, flybridge surround screws, rain gutter screws, gunnel railing mounts and screws, bridge seat base screws... if not sealed, water will find it's way down to the corners of the salon and onto the floor. As you mentioned, window will leak too.
Jamie


1985 F-32 270 Crusaders
1988 Sea Ray 23 350 Merc.
Trojan. Enjoy the ride...

-I don't wanna hear anyone whine...Anymore!
-You might get there before me, but you still have to wait for me, for the fun to start!
User avatar
bjanakos
Moderate User
Posts: 498
Joined: Mon Sep 29, 2014 1:00 pm
Location: Richmond, TX.
Contact:

Re: Water ingress - Salon F-32

Post by bjanakos »

I have a hard-top, so no bridge. There is some hardware on top: hand rails, a GPS and a horn. Plan to re-bed all of that come spring.
User avatar
captainmaniac
2025 Gold Support
2025 Gold Support
Posts: 1922
Joined: Sat Apr 30, 2005 10:26 pm
Location: Burlington, Ontario

Re: Water ingress - Salon F-32

Post by captainmaniac »

You should also check out the screws/bolts along the base of the sliding door track, including the ones that hold the rubber stopper for the door... they could also need re-bedded.
User avatar
bjanakos
Moderate User
Posts: 498
Joined: Mon Sep 29, 2014 1:00 pm
Location: Richmond, TX.
Contact:

Re: Water ingress - Salon F-32

Post by bjanakos »

captainmaniac wrote:You should also check out the screws/bolts along the base of the sliding door track, including the ones that hold the rubber stopper for the door... they could also need re-bedded.
In fact. that board that those screws are suppose to hold has fallen off into the bilge. :shock: It looks OK. No rot. But the boat has been sitting for a year and whoever de-comed the boat had placed all 3 of the group 29 batteries there. I'm hoping I can re-fit it with some 1/4-20 SS-bolts and fender washers.
User avatar
DAVIDLOFLAND
Moderate User
Posts: 352
Joined: Mon Oct 11, 2010 7:02 pm
Location: Anchorage, Alaska

Re: Water ingress - Salon F-32

Post by DAVIDLOFLAND »

Stripermann2 wrote:Any hardware on the bridge, railing screws, flybridge surround screws, rain gutter screws, gunnel railing mounts and screws, bridge seat base screws... if not sealed, water will find it's way down to the corners of the salon and onto the floor. As you mentioned, window will leak too.
+1
You can also take on water through your louvered engine room vents. They have several places where the sealing fails.
1977 F-32 INSTANT FUN "Just Add Water"
My Forever boat - O/O 30 years and counting
Yanmar 6BY3-260's
User avatar
bjanakos
Moderate User
Posts: 498
Joined: Mon Sep 29, 2014 1:00 pm
Location: Richmond, TX.
Contact:

Re: Water ingress - Salon F-32

Post by bjanakos »

Thanks for the input everyone. I'll be digging into it more on my next trip over there.
Post Reply